U.S. power cord usage
With the development of the economy and technology, the earth has become a village, and products from all over the world can be purchased at home. This is how the American power cord appears in everyone's life. Many consumers buy American power cords out of curiosity, but due to the lack of safe use knowledge, there are many wrong ways to use American power cords, and there is a great safety hazard. So what aspects need special attention when using the US power cord.
Before using the US power cord, consumers should understand that the product specifications of the US power cord are different from the domestic power cord production specifications, and the voltage requirements are very different from those of the domestic power cord. See the manual for some precautions. Consumers who can use the Internet can use the Internet to understand the use of American power cords, and use them as needed after understanding to ensure the safety of use. Attention should also be paid to the use of electrical appliances. When using the American power cord to connect the electrical appliance, make sure that the voltage of the American power cord can meet the needs of the electrical appliance. If the needs of the electrical appliance cannot be met, a short circuit will occur, resulting in electrical damage.
The cx wire company reminds everyone that overloaded power lines are prohibited. If the load is greater than the capacity increase, it needs to be applied to the power sector. On the basis of selection, the fuses of electrical machines and the load are prohibited from being compatible with any copper, iron, or aluminum wire to replace the fuse. In the installation and replacement of fuses, wind power is required, and then installation is required to meet the fusion requirements; if the fuses are frequently hit, an electrician's factor needs to be determined to eliminate the fault. It is necessary to install a "leakage protector" in the area without corrosive gas and dangerous goods, and often test the integrity and sensitivity to ensure electric shock. In case of electric leakage, the power can be cut off immediately to protect personal safety.
U.S. power cord distribution lines. Plugs, sockets, light fittings, and other facilities need to be kept in good condition for aging, cracked and broken parts that need to be replaced; power cords may not be on the ground to prevent dropping damaged insulation. When laying the room wiring, the live wire and the neutral wire need to be marked, which must be the same as the wires, and it is forbidden to connect them incorrectly. Wiring is forbidden to be immediately laid on combustible materials, such as wiring must be on wood and porcelain beads.
