Power cord plug molding bad common plug malady and power supply in the use of the process of fever
2021-05-19 [ COMPANY NEWS ]
Common disadvantages of poor molding 1. Insufficient injection volume 1. The injection volume and plasticity are not enough. 2. The amount of rubber material is not enough. 3. The injection pressure is too low. 4. The temperature of the rub......
Why are there 2 holes in the plug?
2021-01-15 [ COMPANY NEWS ]
Nowadays, it can be said that there are more and more household appliances, such as chargers for charging our mobile phones, computers that we must use in our daily work, and televisions for our entertainment at home. These are all very imp......
Why are plugs different in different countries around the world?
2020-08-11 [ INDUSTRY NEWS ]
Why do you need to bring an adapter when you go abroad? Because most of the countries in the world are for political independence or standardization issues? Here are the answers for you Western media said that people who travel abroa......
Plug wire: the left pole of single-phase 2-hole socket is connected with N wire
2020-07-14 [ INDUSTRY NEWS ]
The left pole of the single-phase 2-hole socket is connected to the N wire (zero wire), and the right pole is connected to the L wire (live wire); the left pole of the single-phase three-hole socket is connected to the N wire, the right pol......
Manufacturing process of power cord
2020-03-12 [ COMPANY NEWS ]
Power cord copper, aluminum monofilament drawing The copper and aluminum rods commonly used in power cords are used to pass through one or several die holes of a drawing die at room temperature to reduce the cross-section, increase the leng......